Anchoring

Talk all things pocket cruiser.

Moderators: sal, matthaler

User avatar
scoob
Posts: 911
Joined: Mon Jan 03, 2011 4:36 pm
Location: Golden, CO
Contact:

Anchoring

Postby scoob » Mon Nov 27, 2017 1:33 pm

I just love going for a cruise and finding a quiet cove away from all the other boats. These are one of many moments where a small trailer sailor like the Sage 17, Sage 15 and SageCat do what other boats can’t. Gunkholing requires an anchor. Here I’ll discuss how I store, launch and retrieve an anchor on a Sage.

When cruising I carry two anchors on the boat. Each set of ground tackle is in an anchor bag and has 200’ of rode (rope) and 10’ of chain. In addition I also carry an extra 200’ of rode. The anchors, their rodes & chains & bags and the spare rode fit easily in the Sage 17, 15 or SageCat cockpit lockers. My usual practice is to keep the ground tackle in the starboard cockpit locker.

When I come into an anchorage I take out the anchor I’ll be using and set it and its bag of chain & rode on the cockpit floor. Once the anchoring location I like is found I lower the anchor off the aft starboard over the cleat. Why here? Well this keeps the rode away from the outboard’s prop and single handing keeps me at the helm v. going forward to the bow.

I use the motor to set the anchor and tie off the rode to the aft starboard cleat. Now, this is important, it is not safe to anchor off the transom. Why? If the sea comes up the waves crashing into the transom can also fill the cockpit! There are also higher stresses put on the boat and anchor as the waves hit the transom. Finally … it is really uncomfortable!

After watching how the boat swings and assuring the anchor is set, leaving the rode tied to the starboard stern cleat, I go forward with the anchor bag and rode and tie to the bow cleat. For added safety I tie the bitter end of the rode around one of the bow pulpit stanchions. I then return to the cockpit and release the rode at the stern cleat (adding about 15-20’ of scope to my anchor set).

The boat will now swing bow to the wind and all is ready for a wonderful evening ‘on the hook’.

When i’m ready to retrieve the anchor I go forward and retrieve the rode from the bow cleat and re-secure to the starboard stern cleat. I then pull the anchor rode into the cockpit floor until the rode is almost vertical. I now get the boat ready to leave (ie, take off the sail covers, lay out the sheets, collect the anchor bag from the bow, start the outboard, etc). As the boat rocks it will loosen the anchor making it much easier to raise … especially if it was very well set it deep sticky mud!
I raise the anchor and lay it and the rode on the cockpit sole to drain excess water. Once I have left the anchorage I then stow the anchor, chain, rode & bag back into the starboard cockpit locker.

As part of a longer video of me cruising on a Sage 17 you can watch me using the above system. Here is a link -



SKIP AHEAD to to 5 minutes at 15 seconds to see the anchoring system being used!

Let me know what you think.

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest